Today I was searching for "garage" lifting points other than the pinch welds & ended up with a blank diagram (with
Japanese symbols in red) while using the K13 Workshop manual I found on this forum (39.9MB)
I recently had the scissor lift jack fail on another car (it just started binding) & would prefer to use a hydraulic jack/floor jack to lift my Micra.
I don't want to damage my pinch welds which seems easy to do even with hockey pucks/slotted pads installed on a jack, especially if using a rolling floor jack that cant roll because of uneven surfaces which could cause the car to fall.
Today I found a PDF version of the workshop manual (143MB) that is searchable & located the same page but the picture worked OK.
I plan to spray some yellow paint on the 2 "garage jack points" so I can find them easily later.
I do plan to use a hockey puck on top of my floor jack to protect the underbody paint (if there is any there)
Here is the DL Link
https://www.workshopservicemanual.co...2010-2017.html