Space saver 18
Space saver 18
N/A Subaru Addict...
First Nissan Commuter
Space saver 19
N/A Subaru Addict...
First Nissan Commuter
Space saver 20
N/A Subaru Addict...
First Nissan Commuter
Sounds like a big project. Thanks for sharing for future DIYers.
__________________________________________
View my fuel log 2015 Micra S manual: 5.0 L/100 km ... 56.5 mpg (Imp) ... 20.0 km/L ... 47.0 mpg (US) ...
Bobaganousch (02-01-2021)
Man, what a lot of work for a fairly simple problem, eh?
Thanks again.
__________________________________________
View my fuel log 2015 Micra S manual: 5.0 L/100 km ... 56.5 mpg (Imp) ... 20.0 km/L ... 47.0 mpg (US) ...
I have the same issue.
My heat knob wasn’t turning and then I heard it pop.
Taking it out and trying to reattach did not work.
My temp solution. Pull back the panel by your right foot( gas pedal )
Locate the piece that opens and closes the flap allowing hot air into the cabin.
* note you push it up and away, toward the front of the car. *
I feel that if the whole assembly is not required to change then just removing the center divide and radio console and cup holders you should have enough access to repair / replace.
But this information is still HIGHLY useful. So thank you.
__________________________________________
View my fuel log 2015 Micra S manual: 7.7 L/100 km ... 36.8 mpg (Imp) ... 13.0 km/L ... 30.6 mpg (US) ...
MetroMPG (02-25-2021)
I found the trick with the Green SRS clips is to twist them with bend nose pliers
My blend door needs this service also, I also ended up breaking off one of the teeth inside the hot/cold knob.
I was able to remove the knob assembly from the rest of the HVAC controls, and open it up to remove the tooth ( Which had lodged into the other teeth, and completely jammed up the knob)
__________________________________________
View my fuel log 2015 Micra SV manual: 7.4 L/100 km ... 38.4 mpg (Imp) ... 13.6 km/L ... 31.9 mpg (US) ...
MetroMPG (03-05-2021)