Results 1 to 3 of 3

Thread: Caliper Mounting Bolt Spinning & Won't Come Out

  1. #1
    Junior Member
    Join Date
    May 2020
    Location
    BC
    Posts
    2
    Garage empty: add car
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Caliper Mounting Bolt Spinning & Won't Come Out

    I decided to have a first go at replacing my brake pads and rotors today and everything went well but for ending up with one of the caliper bolts that screw into the pins seemingly being overtightened and stripping. The guide I watched said to tighten to 20 but upon tightening it back up I realised it wasn't getting tight and was just spinning.

    When I turn it, the pin does move slightly but I've tried holding the pin firmly in place but the bolt still just spins. My questions:

    - Is this a safety concern? With the bolt in place I'm assuming it is still doing it's job of holding the plate in place and that this just becomes a problem the next time I want to remove that bolt and do some brake work?
    - If I do need to get it addressed now, any suggestions on how to get it out!?



  2. #2
    Senior Member
    Join Date
    Aug 2020
    Location
    Canada
    Posts
    119
    Thanks
    16
    Thanked 35 Times in 31 Posts
    Show in picture which bolt u r talking about its really hard to follow as per your post what exactly went wrong. Anything with brakes is safety concern for sure.

  3. #3
    Senior Member MrMicra2015's Avatar
    Join Date
    Aug 2016
    Location
    Vancouver BC
    Posts
    732
    Thanks
    154
    Thanked 125 Times in 97 Posts
    this may be a safety concern...possibly the knuckle needs replacement ...did you torque inch pounds or ft lbs?

    so worst case thoughts

    the bolt backs out hits wheel?
    cant comeout but caliper now has one bolt and pivots

    WORST CASE
    wheel locks or POSSIBLY no brakes...but is 2 separate system so SOME brakes left.

    my guess would be wheel locks before anything else..but ive never even heard of that!!!!!!!!!!


    Last edited by MrMicra2015; 07-30-2022 at 10:40 PM.
    2015 Micra S (manual)
    no A/C /no power options/ block heater/4x 2 Ohm speakers...all factory stock in 2015
    Feb 2015 build
    9,999 purchase price + tax..no additional 1600$ because it was a 2015 purchased in 2016
    so receipt says $8,399....+1600 .... so they look good i guess...for a brand new car!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •