Results 1 to 1 of 1

Thread: resetting you nissan micra k13 is very easy

  1. #1
    Junior Member
    Join Date
    Jul 2018
    Location
    indonesia
    Posts
    12
    Garage empty: add car
    Thanks
    0
    Thanked 4 Times in 3 Posts

    resetting you nissan micra k13 is very easy

    when you clean TB (throttle body) dont push the butterfly of TB you will end up buying new one

    but two ways:

    1. key on BUT NOT START - press the gas pedal with stone or else then clean (off course after removing filter housing)
    clean it by rag and spray carbon, OR

    2. dismount the TB - clean it but NEVER press the buterfly just spray 2 sides with carbon clean


    3. install back correctly if one of the tubes is not plug in you will end up high and low rev automoatically horroful sound usually the very back small tube

    4. THIS IS HOW YOU TO RESETTING THE ECU - mandatory to nissan micra / march (CANNOT BY DISCONNECT NEGATIVE BATTERY BECAUSE THIS IS DRIVE BY WIRE / THROTTLE BY WIRE) -

    ====
    1. key on wait until all indicators are on (no more than 3 seconds)
    2. press GAS pedal 5 times (no more than 5 seconds) then release the pedal
    3. wait no more than 7 seconds
    4. press pedal again until the indicator blinks (usually no more than 15 second) IF MORE START FROM NO.1
    5. if the indicator has been blinking release pedal one time than directly PRESS AGAIN GAS PEDAL until the blinking become faster than release the gas pedal and wait
    6. CONGRAT you ECU/ECM HAS BEEN RESET

    7. turn off key - drink coffee then start the engine





    Last edited by micra-indo; 07-14-2018 at 09:13 AM.

  2. The Following User Says Thank You to micra-indo For This Useful Post:

    Pete (07-19-2018)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •