Results 1 to 4 of 4

Thread: Complete sound system finally installed.

  1. #1
    Junior Member
    Join Date
    Oct 2016
    Posts
    22
    Thanks
    0
    Thanked 10 Times in 5 Posts

    Complete sound system finally installed.

    Its been a few months but i finally installed my stereo system.

    2017 Nissan Mirca complete stereo install. https://imgur.com/gallery/EkQSg

    Hertz Mpk165p.3 Components.
    Hertz Mp250 D.4 10" subwoofer
    Focal FPX 5.1200 5 channel amp
    Kenwood 9904s Head unit.



  2. The Following User Says Thank You to jordan2110 For This Useful Post:

    MetroMPG (01-21-2018)

  3. #2
    Senior Member MrMicra2015's Avatar
    Join Date
    Aug 2016
    Location
    Vancouver BC
    Posts
    882
    Thanks
    224
    Thanked 150 Times in 121 Posts

    looks good!

    could you expand on how you routed the power wire for the amp and the grounding of the deck ?
    2015 Micra S (manual)
    no A/C /no power options/ block heater/4x 2 Ohm speakers...all factory stock in 2015
    Feb 2015 build
    9,999 purchase price + tax..no additional 1600$ because it was a 2015 purchased in 2016
    so receipt says $8,399....+1600 .... so they look good i guess...for a brand new car!

  4. #3
    Member
    Join Date
    Jun 2017
    Location
    Toronto
    Posts
    76
    Garage empty: add car
    Thanks
    1
    Thanked 13 Times in 8 Posts
    Looks great!

  5. #4
    Junior Member
    Join Date
    Oct 2016
    Posts
    22
    Thanks
    0
    Thanked 10 Times in 5 Posts
    Quote Originally Posted by MrMicra2015 View Post
    looks good!

    could you expand on how you routed the power wire for the amp and the grounding of the deck ?
    For the ground point, in the trunk along the hatch side in the center there is a black tie off point for a car seat i believe i undid the bolt remove the tie anchor sanding the paint away from around the bolt hole, attached a ring connector to the ground put the bolt threw it and inserted the bolt back into its hole without the tie off anchor.


    For routing the power cable, i went up the drivers side, i remove the door sills and you will see 2 white rings at each door under the sills, with wires already running through them. The rings hole the wires in place. There is enough room to run my power cable along the existing wires and threw the white rings.


    To get through the fire wall, there is a large grommet under the drivers side dash on left side with many wires running through it, it is quite large so i made a small cut in the grommet safety away from the existing wires and pushed my grounding cable through that way.



  6. The Following User Says Thank You to jordan2110 For This Useful Post:

    MetroMPG (01-21-2018)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •