Saw this on ebay, can only wish could engine swap it without all the crazy costs of bigger brakes and such hehe
Pulsar SSS MR16 1.6 Turbo 190HP
Car-parts.com is a car yard site and you can source a juke engine and tranny.
I believe it's about $2500 of a decent eng/trans with turbo and all the fixings
You need a support welded on the the passenger side strut tower and the rest is mechanic wizardry.
But yes ... turbo vs swap .. monetarily it's makes more sense to just get a swap. Then to spend the same
On a turbo and only get 170 unreliable donkeys or basically and lighter mini juke ( same chassis and general shape )
"Mijukecra" - too long for a customized license plate?
View my fuel log 2015 Micra S manual: 5.0 L/100 km ... 56.5 mpg (Imp) ... 20.0 km/L ... 47.0 mpg (US) ...
Thought this would be an appropriate thread to share this:
Looks like a turbocharged k13 in Brazil and appears to have untouched internals. Just a bolton custom turbo kit.
Their dyno results:
I wonder how much abuse the stock internals can take with that setup before it goes pop!
That's a simulated crank horse power. It's using an adjustment table
If that were true, crank hp would be 230hp an 218tq.
If simulated crank. Wheel hp would be 181.5hp 168tq
The transmission is rated for 171 ft lbs
There base started at 130.3hp and 124.4ft lbs.
from a k&n filter.
We know from Injen oem vs aftermarket dyno the drive train power loss is about 15-17%crank to wheel.
stock 94hp/93tq >injen 98hp/97tq
They did increase cv by 77.2 or 76hp and kg/m 9.5 or 68.7ft-lbs
Math backs it up:
207hp x 11.5afr (.55bscf/60) 21.82 - 14.7 =7.12 (.49bar) they used .51bar that difference is altitude
If you look at pull 1/2/3
3 is the "big number pull"
Around 5k rpm tq is locked at 25kg/m
I should be tuned to hit 25 fast and hold as long as possible ( 6000+rpm )
It detunes in the 3rd pull from peak because of timing needed to retard knock.
It climbs again after torque declines because less knock inhibited.
If I was tuning this car I would increase the octane rating so I can increase timing an hold 25kg/m
25kg/m is 180 crank ft-lbs 153at the wheel.
I believe the "1st" pull is the refined tune and the "3rd pull" is the "auto tune" max torque before knock run.
The dyno chart in the middle is the "1st pull" 188cv > 186crank hp / 24.3kg/m > 175 crank tq
With a linear tq/hp line. ( 158 wheel hp / 149 wheel Tq ) seems legit now right?!?
This is a common thing in car scene, using certain units of measurement and different dyno modes to produce inflated results
For comparison the Greek turbo kit produced 149 crank ( sim ) 101 wheel hp with 146 ft lbs @ .3bar or 5 psi.
This is at .5 bar or 7 and a bit psi ...
Last edited by IMPUL; 09-25-2017 at 03:17 PM.
View my fuel log 2015 Micra S manual: 7.7 L/100 km ... 36.8 mpg (Imp) ... 13.0 km/L ... 30.6 mpg (US) ...