Finally replace the front suspension on my 2015 Micra and can confirm the parts from a versa note fits exactly the same.
Have fun on that top nut and watch your knuckles!
Type: Posts; User: Speg
Finally replace the front suspension on my 2015 Micra and can confirm the parts from a versa note fits exactly the same.
Have fun on that top nut and watch your knuckles!
Any updates on this? What style worked for you?
I am currently in need of replacing my front and rears
Anyone know where to get a compete set of front and rear suspension, aftermarket OEM style or part numbers?
Not too sure if the versa suspension would fit? TIA
Thank you so much!
I tried searching before but had no luck.
Now to do the front and rear suspension, can you confirm if the versa strut and shocks are the same for the Micra?
Thanks 👍
Any luck with your suspension? I too am looking to replace front and rear, would prefer loaded assemblies
Hi
Any tips or tricks on replacing the serpentine belt on a 2015 Micra with AC?
Transmission and line is great. Found a resonator pipe at my local wreckers off a newer car for $100 and used a split flange to replace the one that broke off at the muffler. So far so good........
Actually, the entire pipe broke off at the small built in heat shield, I welded the bottom side bit can't access the top, unless I cut it off and reweld. The flange broke off as well and I used a...
Looks and sounds great!
Anyone have the part number for the stock resonator pipe or know where to get one?
Thanks, will look into it
So I took it into a transmission shop (avoided the dealer) they replace the steel line with a rubber line and refilled the tranny all for under $200!, They said everything looked good and no burned...
I'm going to take it to a transmission shop, that's for the advice.....fingers crossed
We'll, the wife had an emergency at work (works at the hospital) and took her car and it broke down. She said it won't shift out of 1st gear, guessing her fluid is low from the leak.
Going to tow it...
I will grab some pictures today.
It is a rubber line off the pan that leads to a steel line with a hose clamp. The first bend in the steel line snaps into a plastic clip under the rad with a second...
It's the steel line that looks like is leaking, no connections near that point
It looks a bit corroded around the plastic retaining clip, I moved it around a bit and is leaking worse now. Trying to find a part number or diagram showing this part.
One good thing, my underbody...
I have a leak on what looks to be a transmission cooling line, runs off the transmission oil pan and along the bottom of the rad.
Anyone have had to replace this?
How much$?
No problem, I realize shipping cost was a bit high but still the cheapest I could find to receive the part in 2 days, also a small price to pay to keep the wife happy
Step 1 remove harness
Step 2 remove two Phillips screws
(mine had pink paint on the heads)
Step 3 remove old resistor (bad one shown on right side in picture, small burn spot noticeable)
Step 4...
Finally replaced the resistor today and it is in fact located on the drivers side above the gas pedal, 10 minute fix but mainly due to the location, definitely puts your flexibility to the test. Use...
Thank.you so much
Thanks!
Just had mine go as well, they are usually attached to the side of the blower motor behind the glove box. Haven't pulled mine yet, does anyone have the part #?