Search:

Type: Posts; User: Plutus

Page 1 of 4 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    13
    Views
    602

    Go to the body shop and ask to solve the problem...

    Go to the body shop and ask to solve the problem they will weld it or go to muffler shop and they will also offer reasonable solution.
  2. Replies
    6
    Views
    644

    Have u seen or asked in dealerships how many...

    Have u seen or asked in dealerships how many engines and transmissions below 100k are they fixing? There are too many variables there that manufacturers cant force anyone to do. There is no...
  3. Replies
    10
    Views
    766

    Hope u reset errors before testing. And yes if...

    Hope u reset errors before testing. And yes if error is still thete replace
  4. Replies
    10
    Views
    766

    There are 2 one on intake and one on exhaust...

    There are 2 one on intake and one on exhaust intake is easy exhaust should be harder but if spark plugs are easy job then u wouldnt have any issue accessing it. I would just clean intake side...
  5. Replies
    10
    Views
    766

    For vvt solenoid u dont need to take anything but...

    For vvt solenoid u dont need to take anything but solenoid itself. For spark plugs too much disassembly and gasket replacements required. And 129k km is nothing for those spark plugs u should be good...
  6. Replies
    13
    Views
    10,009

    Where did u get that?

    Where did u get that?
  7. Replies
    10
    Views
    766

    Its super easy to take out so u can try cleaning...

    Its super easy to take out so u can try cleaning it but to change spark plugs in this engine is not an easy job so i wouldnt even call it maintenance item.
  8. Replies
    6
    Views
    644

    Ok here is the dilema with block heater and...

    Ok here is the dilema with block heater and automatic teansmission. When u have cold engine its giving you at least a hint to warm it up before starting to drive because it makes u feel engine is not...
  9. Replies
    6
    Views
    644

    Should be fine. Mine always parked outside starts...

    Should be fine. Mine always parked outside starts always easy at any weather.
  10. Replies
    10
    Views
    1,536

    0w-20 was chosen to comply with emissions....

    0w-20 was chosen to comply with emissions. Besides that less problems with intake solenoid valve after switching to 0w-20. Characteristics of 0w-20 and 5w-30 assuming both are synthetic are in favor...
  11. Replies
    3
    Views
    796

    140km/h is my morning cruising speed on 403....

    140km/h is my morning cruising speed on 403. :-)))))) its always fun to drive slow car fast than fast car slow.
  12. Replies
    4
    Views
    744

    Or if you want to do it scientifically right then...

    Or if you want to do it scientifically right then attach 10kg weight right in the center of the belt between 3 and 4 pulleys and hold ruler vertically and measure deflection it should be ~4mm as per...
  13. Replies
    4
    Views
    744

    Check tension by pressing the belt between...

    Check tension by pressing the belt between pulleys 3 and 4 in the picture. There should be no play if you are pressing with hand from the bottom…well 4mm with 100nm its almost no deflection.
  14. Will fit without any modification dont worry.

    Will fit without any modification dont worry.
  15. Replies
    8
    Views
    1,389

    Right they dont line up. So the only method is...

    Right they dont line up. So the only method is hammer+wd40(before hammering)
  16. Replies
    8
    Views
    1,389

    That method you cant use on micra!

    That method you cant use on micra!
  17. Replies
    8
    Views
    1,389

    You cant drive bolt through carrier bolt hole to...

    You cant drive bolt through carrier bolt hole to take rotors out thats IMPOSSIBLE on micra. Procedure is super easy as i did many vrake jobs and on my own micra too few times to change rotors and...
  18. Next time go all the way through Bbb and consumer...

    Next time go all the way through Bbb and consumer protection agency the court. Always fight if u think u are right! I personally helped too many of my neighbors when i had time last year cos of...
  19. Publish dealer name then. Both your problems are...

    Publish dealer name then. Both your problems are dealer related problems not manufacturer. Even though first problem is engine problem but due to dealership poor service bet nissan didnt even knew...
  20. Cos micra has pretty old but very reliable...

    Cos micra has pretty old but very reliable transmission resetting it is pain in the butt if you dont have oem diag tool handy. Never seen any multibrand diag tool capable of resetting micras tcm.
  21. There is big difference in micras transmission...

    There is big difference in micras transmission and rogues cvt. Micras tcm module is one way adapting. It will ve a bit hard to explain but i will try:
    Micras tcm has aging algorithm built into tcm...
  22. Replies
    0
    Views
    447

    Front brake carrier bolt torque?

    Can someone confirm that front brake carrier bolt torque is 85nm?
  23. Why? My cruising speed on hwy is 130-140 but last...

    Why? My cruising speed on hwy is 130-140 but last tear when pandemic just started and everybody was driving crazy as there were almost no cars on hwy i accidentally accelerated to 160 without...
  24. I would worry more about brakes than fuel system.

    I would worry more about brakes than fuel system.
  25. That solenoid can cause vibration due to not...

    That solenoid can cause vibration due to not holding low rpms but not misfire. Still OP didnt prove with scanner data that he actually is getting misfire. Little offtop mine is at 61K km no problems...
Results 1 to 25 of 94
Page 1 of 4 1 2 3 4