Search:

Type: Posts; User: NotASportsCar

Search: Search took 0.02 seconds.

  1. Replies
    23
    Views
    38,582

    Get a custom made 2" cat-back exhaust made at...

    Get a custom made 2" cat-back exhaust made at Midas or something. You won't believe how restrictive your exhaust system is until you actually look at it. There is a point between the cat and...
  2. Replies
    300
    Views
    623,077

    This beast had a great summer. 5480

    This beast had a great summer.

    5480
  3. Replies
    9
    Views
    14,007

    Nice work, and great job sourcing some sturdier...

    Nice work, and great job sourcing some sturdier sway bar links!
  4. Replies
    4
    Views
    5,202

    Well done. Much cleaner than my approach, and no...

    Well done. Much cleaner than my approach, and no doubt stiffer.
  5. Replies
    1
    Views
    3,957

    If only hub caps were cool. 5270

    If only hub caps were cool.

    5270
  6. Replies
    9
    Views
    14,007

    REAR Jack up the rear of the car by the...

    REAR

    Jack up the rear of the car by the jacking/tow hoop under the rear bumper. Support with stands then position your jack in the middle of the rear suspension beam (use a block off wood or...
  7. Replies
    9
    Views
    14,007

    DIY: Lowering Springs - RS*R Down kit

    DIY Lowering springs

    DHL deliveries are great. For about $355 after shipping and duties, I finally have some drop springs from RHD Japan. https://www.rhdjapan.com/ I debated between Eibach, H&R,...
  8. DIY Mud Guard Install (factory look, aftermarket part)

    DIY Mud Guard Install

    During my first winter with the little go kart, I was getting fed up with the slush build up on my driver's door and the clumping of ice and snow inside the rear bumper. So I...
  9. Replies
    70
    Views
    235,491

    I just pulled the head unit out of my 2018.5...

    I just pulled the head unit out of my 2018.5 today. Needed to trace some speaker wires. I didn't have any luck finding a wiring diagram online for the newer Back-up camera displays. I needed to tap...
  10. I had originally only done the lower mount,...

    I had originally only done the lower mount, underneath the car. This wasn't enough for what i was looking for. However, this one is very easy to remove, and only one wrench required.
  11. With the polyurethane cured, not as particularly...

    With the polyurethane cured, not as particularly aesthetic as the factory rubber, but significantly more rigid. It was time to trim away any excess:

    5179

    Reinstall the mounts, with the bolts...
  12. I covered the lower transmission mount post with...

    I covered the lower transmission mount post with a ziploc bag, and smeared petroleum jelly all over the plastic in order to help it release from the polyurethane:

    5173

    I applied the...
  13. Sun's out, Mounts out. (Modified engine+transmission mounts)

    The sun actually came out today... and it was only zero degrees. Off work early, so I finally had a chance to tackle something that has been irritating me since day one with this car:

    The amount...
  14. Replies
    1
    Views
    3,957

    2018 Nissan Micra SV (Garage entry)

    2018 Nissan Micra SV (Garage entry) (2019-03-02 14:48:37)
Results 1 to 14 of 14