Search:

Type: Posts; User: Azmodon

Page 1 of 11 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    3
    Views
    628

    Do you mean me? lol I'd actually defer to...

    Do you mean me? lol

    I'd actually defer to 514Xave (Post #16 from this page):
    https://micra-forum.com/showthread.php/2312-Custom-audio-box-sub-radio/page2

    I've only ever tied in with custom...
  2. Replies
    25
    Views
    7,155

    You'd also have like an inch less poke than I...

    You'd also have like an inch less poke than I did, so the worst case scenario would be detaching the 3-4 attachment points the liner has with the lip of the fender and either bending them up or...
  3. Replies
    25
    Views
    7,155

    I believe 7.5" is about as wide as you can go...

    I believe 7.5" is about as wide as you can go without poking a bit, +40 at that point would also bring the inside of the tire as close as you would want to your suspension (8" @ +40 I can't say for...
  4. If I've got time this weekend (and weather...

    If I've got time this weekend (and weather permitting) I'll remove the glove box and see what I can see. Since our cars are basically the Versa it should just be 8 screws, pull out the box, and then...
  5. I'm starting to see about a litre every 2K,...

    I'm starting to see about a litre every 2K, (threw in some restore just in case) had zero loss prior to 130K, need to do a full check but at least it's not leaking on to the ground any more lol
  6. I'm having the same issue but haven't even...

    I'm having the same issue but haven't even thought of bothering with it yet - louder music and road noise do their job :P if I get to it before you I'll let you know.
  7. Replies
    3
    Views
    1,031

    Take a wheel off, on the hub towards the rear of...

    Take a wheel off, on the hub towards the rear of the car you'll find the outer tie rod. The stub threaded in to it has the jam nut - loosen the jam nut. The inner tie rod has hex flats - twist the...
  8. There's a plastic tube on the other end of the...

    There's a plastic tube on the other end of the drain hole (attaches to the pan) they call the 'overflow tube'. So the volume of fluid below its upper lip is the volume they want in the device. But I...
  9. "requires mechanical competency" is mechanical...

    "requires mechanical competency"
    is mechanical engineering tech... k thx. The only tool I had was a fork... and I got it done. No panels were pulled, nothing was removed from the car but the...
  10. The procedure I had to follow was because I...

    The procedure I had to follow was because I didn't have a jack - as described. You can obviously access things under the car, from under the car. I was in a parking lot, on a mountain, 8 hours from...
  11. Replies
    5
    Views
    1,658

    dust shields behind the rotor are also notorious...

    dust shields behind the rotor are also notorious for rusting / sagging, making contact with brake bits. I had to bend mine back quite a bit because any time I hit a bump on of them made it sound like...
  12. Replies
    10
    Views
    2,740

    Oh I'll be there, won't know till Friday if I'm...

    Oh I'll be there, won't know till Friday if I'm going solo though
  13. Replies
    10
    Views
    2,740

    *theatrical DUN DUN DOOOONE!* Took all weekend...

    *theatrical DUN DUN DOOOONE!*

    Took all weekend to figure out the mounting... but I can put about 200Lbs on it without budging so... success.

    5450

    5451

    5452
  14. Replies
    5
    Views
    2,002

    Assuming you mean the accessories belt, some have...

    Assuming you mean the accessories belt, some have replaced them at 40K, I think I did mine at 120K. From what I (and some others here) experienced, it seems to become rather squeely when it's worn,...
  15. Replies
    10
    Views
    2,740

    had to get up at 5:30 and drive 2 hours in to the...

    had to get up at 5:30 and drive 2 hours in to the heart of Toronto... couldn't sleep I was so excited... now the fun part.

    5438

    5439

    5440
  16. Replies
    5
    Views
    1,659

    any feathering on the tire itself? or is it a...

    any feathering on the tire itself? or is it a different stock tire than the 2015 era?
  17. Replies
    9
    Views
    2,413

    that's really strange... it's one way to avoid...

    that's really strange... it's one way to avoid the rusting out issue I had on the cat's flange but to just have is welded together from the flex pipe back seems... just looking at the part numbers...
  18. Replies
    7
    Views
    2,041

    as far as mileage goes, since I bought the car...

    as far as mileage goes, since I bought the car (with my driving habits) I always averaged 6.9-7.1 on the computer. It had crept up to 7.4 a few months ago, and within the last 2 weeks had gone to 8.0...
  19. Replies
    7
    Views
    2,041

    Spark pluggy goodness

    It only took a little over an hour to get done, I was expecting more of a fight lol but I had been wondering why my fuel efficiency had been dropping. Now I'll see how the Denso 4711's fair.

    Stock...
  20. Replies
    4
    Views
    1,656

    it is a 70A vs the 55A you went with, so I'm...

    it is a 70A vs the 55A you went with, so I'm expecting it to be quite ridgid, but having a second set means I can mangle these (drill out sections if they're really too much) and not worry about just...
  21. Replies
    17
    Views
    4,626

    Mine have started to fold right over - I'll be...

    Mine have started to fold right over - I'll be cleaning them out, bending them back, reinforcing them with square tubing, and then filling the multiple layers with Devcon S-50
  22. Replies
    13
    Views
    3,872

    Sticky: Since the weather should hold out, it's not...

    Since the weather should hold out, it's not uncommon to see 20+ on opening weekend... but I have had it happen where I'm the only person in the entire parking section lol. There's also the Z-clubs...
  23. Replies
    4
    Views
    1,656

    tape peeled off 5331 5332

    tape peeled off

    5331

    5332
  24. Replies
    4
    Views
    1,656

    Poly Motor Mounts?

    Inspired by another member, but wanting to go slightly overboard as per my usual :P

    Picked up a new set of motor mounts, cost about $90USD for all three. As the transmission uses a pillow mount,...
  25. I have my demon eyes running through the provided...

    I have my demon eyes running through the provided grommet, drilled another hole beside it and have a cable gland securing the power line for the subwoofer. The wires come in above and to the left of...
Results 1 to 25 of 254
Page 1 of 11 1 2 3 4