When I purchased my 2019 Micra used with 8000km on it, I noticed that the dust caps were siliconed because whoever removed them previously damaged them.
Over the course of the past few weeks I’ve...
When I purchased my 2019 Micra used with 8000km on it, I noticed that the dust caps were siliconed because whoever removed them previously damaged them.
Over the course of the past few weeks I’ve...
The control on it are the same as the stock wheel same layout left side is radio control right side is cruise, all work the same as it is the same plug for controls.
Today I was searching for "garage" lifting points other than the pinch welds & ended up with a blank diagram (with
Japanese symbols in red) while using the K13 Workshop manual I found on this forum...
Hey hey! My parent's Micra Muffler rusted at the flange as well. Had access to a welder but no material left to weld. The Versa Note Muffler is a direct bolt on. Only differences were the diameter of...
The diameter of the pipe is 1.5 in
Sauga. If it’s not fiscally responsible. Dont worry about it. You tried your best.
Right?! No worries man is someone in this community needed it by now they would’ve spoken up feel free to throw...
Sauga. If it’s not fiscally responsible. Dont worry about it. You tried your best.
Happened across this post today on Kijiji that there is a Caspian Sea SR Micra in at a Pic n Save in Woodstock Ontario. Pics look pretty rough, but the spoiler looks to be in good shape at least,...
You've probably figured this out by now but there are two clips in the bottom of the center console on the back bottom of it around the middle bump in the rear passenger foot space.
The clamps...
Well, it took me a while to get a chance to install the 15mm spacers but I finally got it done.
I'm not sure if the pictures do it justice but there's definitely a noticeable difference in person....
Here's the latest K13 2010-2017 workshop manual which includes DRL market info (that's us!) and also literally everything else K13 Micra related.
I know folks have been curious about our daytime...
DIY Mud Guard Install
During my first winter with the little go kart, I was getting fed up with the slush build up on my driver's door and the clumping of ice and snow inside the rear bumper. So I...
With the polyurethane cured, not as particularly aesthetic as the factory rubber, but significantly more rigid. It was time to trim away any excess:
5179
Reinstall the mounts, with the bolts...
I covered the lower transmission mount post with a ziploc bag, and smeared petroleum jelly all over the plastic in order to help it release from the polyurethane:
5173
I applied the...
The sun actually came out today... and it was only zero degrees. Off work early, so I finally had a chance to tackle something that has been irritating me since day one with this car:
The amount...
Got the check engine light on?
No fret... no need for an expensive (nor a cheap) ODB-II reader. Our 10k tin cans can read off the display.
Jokes aside, it can become useful
Here's how to read...