Search:

Page 1 of 3 1 2 3

Search: Search took 1.00 seconds.

  1. my limited experience with "harder" poly...

    my limited experience with "harder" poly bushings is your tooth fillings are going to fall out....i think you nailed it with "just replace whole arm"...keep old arm as "fun bushing replacement...
  2. Replies
    3
    Views
    755

    the dog ?

    the dog ?
  3. Replies
    6
    Views
    3,591

    Finding Garage Lifting Points

    Today I was searching for "garage" lifting points other than the pinch welds & ended up with a blank diagram (with
    Japanese symbols in red) while using the K13 Workshop manual I found on this forum...
  4. Replies
    2
    Views
    2,552

    not yet at 88K....

    not yet at 88K....
  5. Replies
    2
    Views
    3,827

    Micra K13 HR12DET Turbo do 260hp!!

    Hi folks

    Recently, In Thailand we have done HR12DET with performance connecting rods
    and it still pulls 260 horsepower with no any problem :o:o61916192

    The Engine Builder name Nono Eco Shop...
  6. 6141 You basically get your fingers between...

    6141

    You basically get your fingers between the dash panel and the bezel that houses the vents and then pull towards you. There are 11 metal clips. It looks like they recommend starting at the...
  7. Technical information about the Micra from Nissan Learning Academy

    I found this amazing document that was linked in a comment on a youtube video I watched.

    If you have a manual transmission- this document shows the fluid capacity, type, and where to fill/check...
  8. Im almost embarrassed to say......(shuffles...

    Im almost embarrassed to say......(shuffles feet)......I wondered if the hard OEM all weather Nissan Micra floor mats might be the problem.....I had to do a shake out of the mats and a vacuum of the...
  9. Replies
    9
    Views
    7,035

    Update. I did give it a smart smack, and...

    Update. I did give it a smart smack, and something obviously "caught". So it is not longer loose but it is also not smooth where it meets the other bit. But I no longer fear it falling off, so...
  10. Replies
    5
    Views
    4,822

    Its very common problem on hr16de its intake...

    Its very common problem on hr16de its intake solenoid valve needs to be replaced.
    Engine can stall on idle. Then u have to play with gas pedal to make it start again. Dont go to dealer it will be an...
  11. Replies
    3
    Views
    5,717

    Cheap Glove-box Light for Meep

    I like the nice roomy glove-box in the Micra but does not come equipped with a glove-box light. This little $5 upgrade can be installed in seconds and works like a charm - I do need to get some...
  12. How To Get A Fold Flat Cargo In A Nissan Micra - EASY WAY

    To bad Nissan Canada don't offer the March Cargo kit here in Canada. I've never had a use for back seats and the Micra does not fold flat, I've seen MetroMPG's awesome post where he built a new...
  13. The Micra's grille has WAY too much unnecessarily...

    The Micra's grille has WAY too much unnecessarily open area. Zero attention paid to aero efficiency gains to be had (not to mention possibly faster warm-up). Whereas the Versa Note (same...
  14. Replies
    9
    Views
    6,681

    Here is a link to an Australian channel that I...

    Here is a link to an Australian channel that I found good as he gives reasons to follow certain procedures.
    https://www.youtube.com/watch?v=uNto8uWiYtw&t=14s
  15. Replies
    9
    Views
    8,038

    Do you have any links to the catch can setup...

    Do you have any links to the catch can setup parts you used for the change?
  16. Hi I have in fact done this and it was really...

    Hi I have in fact done this and it was really comfortable and spacious! I'm away from home and only have a couple of bad pictures but at least you know its possible...

    5102
    5103
    5104

    There...
  17. Replies
    27
    Views
    65,685

    my experience & fix for P0011

    I thought I would share my recent experience with everyone. I got trouble code P0011 but it’s was intermittent and was not always a problem. After checking most parts I found that my intake side...
  18. Replies
    2
    Views
    3,671

    thanks daox and metrompg

    and merry xmas and a great micra new year...EXCELLENT JOB!!!

    off topic....
    i swear i saw a big fat guy get into a micra at the bar and he had must have been 10-12 friends that got into micras...
  19. Replies
    2
    Views
    4,124

    Welcome to the forum, LJ2015! What you...

    Welcome to the forum, LJ2015!

    What you describe is a feature, not a bug. It's designed to hold gears longer than usual when cold to help get the drivetrain and catalytic converter up to...
  20. I found a handy information sticker on the back...

    I found a handy information sticker on the back of my drivers side sun visor about defogging the windshield.
    I have to ask is your AC lamp lit & the compressor cycling 0N/OFF (clicking noise)?
    The...
  21. Maybe you have the ventilation set on...

    Maybe you have the ventilation set on recirculate. Try moving the lever to the other position to get fresh air.

    If you already did that, then maybe you have a leak in the cooling system that is in...
  22. Micra is in the 10 Slowest Cars of 2018 (Wheels/Toronto Star)

    5029

    Ha! I will admit, when I saw the title of this article I was prepared to dismiss it as another hit piece by a horsepower-obsessed blogger.

    But it's got some perspective:



    The...
  23. Your highway number is pretty darn close to the...

    Your highway number is pretty darn close to the average that other manual Micra drivers are getting year round:



    6.6 L/100 km (manuals only)


    From: Micra Fuel Economy Log

    Seems pretty...
  24. Replies
    20
    Views
    28,828

    We have a member here with an SR that experienced...

    We have a member here with an SR that experienced deformation of the rocker panel skirt gasket after getting it sprayed.

    I'll see if I can find it...

    Yup, here it is:

    Thread: Side sill...
  25. Replies
    126
    Views
    187,014

    As I'm constantly covering and re-covering my...

    As I'm constantly covering and re-covering my headliner (third time's the charm?) I've been putting in some 3M sound reduction mat.

    4039
    4040
Results 1 to 25 of 68
Page 1 of 3 1 2 3