I've been doing some research on fitting March coilovers to our North American Micras and wondering if there are any bolt-on solutions for the missing sway bar mounts. Has anyone else bought/had some brackets made up like aftica did in this old thread?
As far as I can tell mounts are needed for the front and the rear...?
If you spec your coilovers for the Nismo S March, than you will get those front coilovers with tabs for the front sway bar links.
Unfortunately this is a case of already speccing coils for a non-Nismo and now trying to source a solution. Lol.
I forget who it was, but someone had a little bracket made up that bolts on to the two bolts at the bottom, and has a hole for the sway bar link. it was in the original lowering thread on the forum.
Thread where they were fabricated:
http://micra-forum.com/showthread.ph...ilovers)/page6
I'll be doing similar, except I plan on putting a third hole in the mounting bracket and bolting through that (camber bolts + alignment are finicky enough, don't need another piece sandwiched in lol)
Are you planning on making them yourself, or do you know a guy?Quote:
Originally Posted by Azmodon
I hope to design and build them myself, just need to make a jig based on the original shock out of wood. Should be fairly simple (went to school for it lol) but if I need help I have machinist and welder friends.
Keep me updated and let me know if you want to make another set for sale! What coils are you trying to install?Quote:
Originally Posted by Azmodon
I have the Tein GSK20-21AS2 (street advance) installed, with stock tires they'd be awesome since you can drop the car about 4 inches (even though the specs say 3" front and 2.6" rear, when I first put them on I dropped 3.875" in the rear). How ever I get it done I'll likely make up a few sets and print out what ever templates are needed, just figuring out torque now