my limited experience with "harder" poly bushings is your tooth fillings are going to fall out....i think you nailed it with "just replace whole arm"...keep old arm as "fun bushing replacement...
my limited experience with "harder" poly bushings is your tooth fillings are going to fall out....i think you nailed it with "just replace whole arm"...keep old arm as "fun bushing replacement...
the dog ?
Today I was searching for "garage" lifting points other than the pinch welds & ended up with a blank diagram (with
Japanese symbols in red) while using the K13 Workshop manual I found on this forum...
not yet at 88K....
Hi folks
Recently, In Thailand we have done HR12DET with performance connecting rods
and it still pulls 260 horsepower with no any problem :o:o61916192
The Engine Builder name Nono Eco Shop...
6141
You basically get your fingers between the dash panel and the bezel that houses the vents and then pull towards you. There are 11 metal clips. It looks like they recommend starting at the...
I found this amazing document that was linked in a comment on a youtube video I watched.
If you have a manual transmission- this document shows the fluid capacity, type, and where to fill/check...
Im almost embarrassed to say......(shuffles feet)......I wondered if the hard OEM all weather Nissan Micra floor mats might be the problem.....I had to do a shake out of the mats and a vacuum of the...
Update. I did give it a smart smack, and something obviously "caught". So it is not longer loose but it is also not smooth where it meets the other bit. But I no longer fear it falling off, so...
Its very common problem on hr16de its intake solenoid valve needs to be replaced.
Engine can stall on idle. Then u have to play with gas pedal to make it start again. Dont go to dealer it will be an...
I like the nice roomy glove-box in the Micra but does not come equipped with a glove-box light. This little $5 upgrade can be installed in seconds and works like a charm - I do need to get some...
To bad Nissan Canada don't offer the March Cargo kit here in Canada. I've never had a use for back seats and the Micra does not fold flat, I've seen MetroMPG's awesome post where he built a new...
The Micra's grille has WAY too much unnecessarily open area. Zero attention paid to aero efficiency gains to be had (not to mention possibly faster warm-up). Whereas the Versa Note (same...
Here is a link to an Australian channel that I found good as he gives reasons to follow certain procedures.
https://www.youtube.com/watch?v=uNto8uWiYtw&t=14s
Do you have any links to the catch can setup parts you used for the change?
Hi I have in fact done this and it was really comfortable and spacious! I'm away from home and only have a couple of bad pictures but at least you know its possible...
5102
5103
5104
There...
I thought I would share my recent experience with everyone. I got trouble code P0011 but it’s was intermittent and was not always a problem. After checking most parts I found that my intake side...
and merry xmas and a great micra new year...EXCELLENT JOB!!!
off topic....
i swear i saw a big fat guy get into a micra at the bar and he had must have been 10-12 friends that got into micras...
Welcome to the forum, LJ2015!
What you describe is a feature, not a bug. It's designed to hold gears longer than usual when cold to help get the drivetrain and catalytic converter up to...
I found a handy information sticker on the back of my drivers side sun visor about defogging the windshield.
I have to ask is your AC lamp lit & the compressor cycling 0N/OFF (clicking noise)?
The...
Maybe you have the ventilation set on recirculate. Try moving the lever to the other position to get fresh air.
If you already did that, then maybe you have a leak in the cooling system that is in...
5029
Ha! I will admit, when I saw the title of this article I was prepared to dismiss it as another hit piece by a horsepower-obsessed blogger.
But it's got some perspective:
The...
Your highway number is pretty darn close to the average that other manual Micra drivers are getting year round:
6.6 L/100 km (manuals only)
From: Micra Fuel Economy Log
Seems pretty...
We have a member here with an SR that experienced deformation of the rocker panel skirt gasket after getting it sprayed.
I'll see if I can find it...
Yup, here it is:
Thread: Side sill...
As I'm constantly covering and re-covering my headliner (third time's the charm?) I've been putting in some 3M sound reduction mat.
4039
4040