Search:

Page 1 of 2 1 2

Search: Search took 1.00 seconds.

  1. Thread: ALLOY RIMS

    by spacewolf
    Replies
    28
    Views
    10,862

    I have been running a set of Fast Aventure wheels...

    I have been running a set of Fast Aventure wheels close to the SR OEM size. No hub rings or anything necessary. Offset is a little more than I wanted but I love them now. Found a set of OEM Nissan...
  2. Replies
    2
    Views
    3,897

    You've probably figured this out by now but there...

    You've probably figured this out by now but there are two clips in the bottom of the center console on the back bottom of it around the middle bump in the rear passenger foot space.

    The clamps...
  3. Replies
    23
    Views
    38,584

    The Kicks idea won't work. It uses a totally...

    The Kicks idea won't work. It uses a totally different intake manifold with intake manifold runners and a specific tune with the CVT to make those numbers.

    Installing a custom ECU is pretty much...
  4. Replies
    5
    Views
    6,450

    Just thread the stock shaft to Nissan spec with a...

    Just thread the stock shaft to Nissan spec with a tap and die set. Canadian Tire even sells the kits/handles (frequently on sale). I believe I ordered the correct thread pitch from Amazon though.
    ...
  5. I did some testing on my end the last two days...

    I did some testing on my end the last two days since replying to this thread.
    It's been -5 to +5 here (all the wind bringing in some warmth from the Pacific).

    Average on my 2017 SV 5MT:
    -...
  6. Replies
    6
    Views
    5,710

    With modern synthetic oil, they say you can run...

    With modern synthetic oil, they say you can run 10,000KMs+ before changing it.
    I decided to give it a shot on my 2017 Micra 5MT with its first oil change. I did end up topping up the oil once...
  7. Replies
    11
    Views
    13,172

    Ice inside the wheel well and forming off of the...

    Ice inside the wheel well and forming off of the bottom of the fender liner is completely normal and happens on every single vehicle. I've lived in Northern Canada most of my life and no other...
  8. Intake/Header/Exhaust - the basic three boltons.

    Intake/Header/Exhaust - the basic three boltons.
  9. 4846 MANIFOLD ASSY-INTAKE Part Number:...

    4846

    MANIFOLD ASSY-INTAKE
    Part Number: 140015RL0A
    Qty per Vehicle: 1
    This part will fit your vehicle if it
    matches the configuration below:
    Fits Year Range: 04/01/2018 to 07/13/2019

    MSRP
  10. I took a look under the hood of the only Kicks on...

    I took a look under the hood of the only Kicks on the lot here the other day when I was at the dealer.

    The intake manifold is much different, even from the other Kicks engine bay pictures online....
  11. Replies
    17
    Views
    17,766

    Leather wrapped my steering wheel

    After looking at a bunch of different options (buying an SR wheel, getting a juke/370z wheel + airbag etc) and the costs associated, I decided to take a chance and manually wrap the SV wheel with one...
  12. I looked into going that route as well and adding...

    I looked into going that route as well and adding in the features I wanted from the SV trim to an S (there was a grey 2016 S model on the lot here clearance for 9500$) but I really wanted AC and it...
  13. Honestly, it wasn't AC alone that steered me into...

    Honestly, it wasn't AC alone that steered me into getting an SV. It was a combination of a few comparative features between the S and SV. Also coming from my old winter beater I really wanted AC and...
  14. HBD to the best Micra forum! :o

    HBD to the best Micra forum! :o
  15. Throttle Actuator Control Motor Circuit Issue (First problem with '17 Micra 5MT)

    Just a quick post on an issue I ran into on Christmas day.

    I took the Micra for a spin around the corner after sitting for 2 days in -30 and initially it started and drove fine. However, after I...
  16. Replies
    22
    Views
    40,127

    Here is it routed. 4153 After putting...

    Here is it routed.

    4153

    After putting close to 2000kms on the old short tube setup with no filter, I'm glad to say the intake was bone dry, no oil. I really can't see there being a need for a...
  17. Replies
    22
    Views
    40,127

    UPDATE

    Been running my current setup for about 1800kms and have been loving it. Still need the new inlet but I haven't had the time or energy to sink into designing it right now.

    Just got and mocked up...
  18. Replies
    59
    Views
    136,247

    Thought this would be an appropriate thread to...

    Thought this would be an appropriate thread to share this:

    https://www.youtube.com/watch?v=k8ysVYx97xo


    https://www.youtube.com/watch?v=k8ysVYx97xo
    ...
  19. Definitely not disappointed! I totally get it...

    Definitely not disappointed! I totally get it haha. My project car is salvage title with a smashed up bumper from a snowstorm. The cosmetics are the last thing I care about on it. Maybe I'll slap a...
  20. Replies
    19
    Views
    30,877

    I'm curious what got you guys into the 2017...

    I'm curious what got you guys into the 2017 Sentra, it's a pretty slick looking rig but it's essentially a slightly heavier sedan with a juke engine. In terms of its class it seems to fall behind its...
  21. Replies
    5
    Views
    11,304

    How do you drive? What kind of conditions do you...

    How do you drive? What kind of conditions do you drive in year round? What feature is most important to you (grip, tread life, sound)?

    For the sake of getting a better tire and overall...
  22. Haven't updated either of these threads in a...

    Haven't updated either of these threads in a while.

    I've been running Daox's for about 1200 kms with the custom intake and it has been awesome. No codes, doesn't appear to be running lean (waiting...
  23. Targa top NSX with but with pop up headlights and...

    Targa top NSX with but with pop up headlights and the revised 3.2L DOHC V6 & 6MT that the 1997 revision got, possibly super charged..

    https://preview.ibb.co/mqfHu5/1998_Acura_NSX_750x421.jpg
    ...
  24. Got the MAF housing on Monday morning and threw...

    Got the MAF housing on Monday morning and threw it in with a ghetto version of the intake I'm trying to put together. It really opened up the engine! I'm in the process of fixing a few things, taking...
  25. I specifically said the opposite of that and not...

    I specifically said the opposite of that and not cuz race car but also yes, as in basic off the shelf bolt-on. Not speaking to the quality of the part, just what it is.

    I want a streetable custom...
Results 1 to 25 of 38
Page 1 of 2 1 2